Other information:
On-vehicle InspectionON-VEHICLE INSPECTION PROCEDURE 1. INSPECT HORN RELAY ASSEMBLY (a) Check the resistance. (1) Measure the resistance according to the value(s) in the table below. Standard Resistance: Tester Connection Condition Specified Condition 3 - 5 Auxiliary battery voltage not applied between terminals 1 and 2 10 kΩ or higher 3 - 5 Auxiliary battery voltage applied between terminals 1 and 2 Below 1 Ω If the result is not as specified, replace the horn relay assembly...
COMPONENTS ILLUSTRATION
*1 CLUTCH START SWITCH ASSEMBLY *2 CLUTCH MASTER CYLINDER PUSH ROD CLEVIS WITH HOLE PIN *3 CLUTCH PEDAL SUPPORT ASSEMBLY *4 NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY
N*m (kgf*cm, ft.*lbf): Specified torque ● Non-reusable part
MP grease - - ILLUSTRATION
*1 TURN OVER CLUTCH PEDAL SPRING *2 NO...