Toyota Yaris: Seat / Seat Heater Switch

Installation

INSTALLATION CAUTION / NOTICE / HINT CAUTION: Wear protective gloves. Sharp areas on the parts may injure your hands. PROCEDURE 1. INSTALL REAR SEAT CUSHION LOCK HOOK (a) Engage the claws to install 2 new rear seat cushion lock hooks...

Components

C..

Other information:

Toyota Yaris XP210 (2020-2026) Reapir and Service Manual: Removal

REMOVAL CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during the manual transaxle assembly removal/installation are shown below...

Toyota Yaris XP210 (2020-2026) Reapir and Service Manual: Lost Communication with ECM/PCM "A" Missing Message (U010087,U012687,U012987)

DESCRIPTION The AWD ECU assembly receives signals from the ECM, steering sensor and skid control ECU (brake actuator assembly) via CAN communication. DTC No. Detection Item DTC Detection Condition Trouble Area Warning Indicate Memory U010087 Lost Communication with ECM/PCM "A" Missing Message When the ignition switch is ON, the IG1 terminal voltage is 10 V or more and the vehicle speed is 60 km/h (37 mph) or more, signals cannot be received from the ECM for 1 second or more CAN communication system AWD ECU assembly ECM Displayed Yes U012687 Lost Communication with Steering Angle Sensor Module Missing Message When the following continues: When the IG1 terminal voltage is 10 V or more, communication with the steering sensor is impossible for 1 second or more When the IG1 terminal voltage is 10 V or more, a condition in which communication with the steering sensor is impossible occurs 1 time or more within a 5-second period, and this occurs 10 times within 60 seconds CAN communication system AWD ECU assembly Steering sensor Displayed Yes U012987 Lost Communication with Brake System Control Module Missing Message When the IG1 terminal voltage is 10 V or more, communication with the skid control ECU (brake actuator assembly) is impossible for 3 seconds or more CAN communication system AWD ECU assembly Skid control ECU (Brake actuator assembly) Displayed Yes PROCEDURE 1...