Toyota Yaris XP210 (2020-2026) Reapir and Service Manual
Toyota Yaris XP210 (2020-2026) Reapir and Service Manual
Repair Manual for fourth generation Toyota Yaris. The key to Toyota meeting its ambitions for the new Yaris is its first application of the Toyota New Global Architecture - TNGA - philosophy to a small car, introducing the modular GA-B platform that will underpin a series of new models. The GA-B platform is central to the Yaris' improved dynamic performance, giving a lower centre of gravity and much greater body rigidity. It also enabled the designers to create a more distinctive and powerful-looking car with an appealing and individual identity.
- General
- Audio & Visual & Telematics
- Brake
- Drivetrain
- Axle And Differential
- Clutch
- Drive Shaft / Propeller Shaft
- Ea67f (manual Transmission / Transaxle)
- Gf1a (transfer / 4wd / Awd)
- Engine & Hybrid System
- Cruise Control
- G16e-gts (cooling)
- G16e-gts (emission Control)
- G16e-gts (engine Control)
- G16e-gts (engine Mechanical)
- G16e-gts (fuel)
- G16e-gts (intake / Exhaust)
- G16e-gts (lubrication)
- G16e-gts (starting)
- Stop And Start
- Power Source & Network
- Steering
- Suspension
- Vehicle Exterior
- Vehicle Interior
Customizable Features
The following customizable features can be set or changed by your
Toyota dealer. Consult your Toyota dealer for details.
Additionally, some of the customizable features can be changed by
the customer depending on the feature...
General
h..
Other information:
Toyota Yaris XP210 (2020-2026) Reapir and Service Manual: Terminals Of Ecu
TERMINALS OF ECU CHECK AWD ECU ASSEMBLY (a) Measure the voltage and resistance of the connector. Terminal No. (Symbol) Terminal Description Condition Specified Condition O119-1 (GND) - Body ground Ground Always Below 1 Ω O119-2 (BSLC) - O119-1 (GND) AWD ECU assembly power supply Always 11 to 14 V O119-13 (T1H) - O119-1 (GND) Temperature sensor (+) input Ignition switch ON 0...
Toyota Yaris XP210 (2020-2026) Reapir and Service Manual: Installation
INSTALLATION CAUTION / NOTICE / HINT HINT: Use the same procedure for the RH and LH sides. The procedure listed below is for the LH side. PROCEDURE 1. INSTALL SIDE AIRBAG PRESSURE SENSOR (a) Check that the ignition switch is off. (b) Check that the cable is disconnected from the negative (-) auxiliary battery terminal...
Categories
- Manuals Home
- Toyota Yaris Owners Manual
- Toyota Yaris Service Manual
- Engine & Hybrid System
- G16e-gts (engine Mechanical)
- How to use USB mode
- New on site
- Most important about car
Keys
To use the auxiliary key, press the knob and pull out the auxiliary key from the smart key.
Copyright © 2026 www.toyaris4.com