Toyota Yaris: General / Setup
ComponentsCOMPONENTS ILLUSTRATION
*1 MECHANICAL KEY *2 TRANSMITTER BATTERY *3 TRANSMITTER HOUSING CASE *4 TRANSMITTER HOUSING COVER RemovalREMOVAL CAUTION / NOTICE / HINT NOTICE: Take extra care when handling these precision electronic components...
ProcedurePROCEDURE PROCEDURE 1. CUSTOMIZE LANE TRACING ASSIST SYSTEM Click here
2. CUSTOMIZE WIRELESS DOOR LOCK CONTROL SYSTEM Click here
3. CUSTOMIZE SMART KEY SYSTEM (for Entry Function) Click here
4...
Other information:
INSTALLATION CAUTION / NOTICE / HINT HINT:
Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.
PROCEDURE 1. INSTALL REAR DRIVE SHAFT INBOARD JOINT SHAFT SNAP RING (a) Install a new rear drive shaft inboard joint shaft snap ring to the rear drive shaft assembly...
REPLACEMENT CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during the transaxle case oil seal and front dirve shaft oil seal RH removal/installation are shown below...
Categories
Stop the vehicle completely.
Manual transaxle:
Shift into neutral and set the parking brake.
Automatic transaxle:
Shift the selector lever to the P position and set the parking brake.
Press the push button start to turn off the engine. The ignition position is
off.
read more