Toyota Yaris: Setup / When Replacing Or Removing/installing Parts

When Disconnecting Or Reconnecting Battery Terminal

Automatic Learning ChartAUTOMATIC LEARNING CHART AUTOMATIC LEARNING PERFORMED WHEN CABLE IS DISCONNECTED / RECONNECTED TO AUXILIARY BATTERY TERMINAL When the cable is disconnected / reconnected to the auxiliary battery terminal, systems temporarily stop operating...

Ecu Configuration

ECU CONFIGURATION STABILIZE A POWER SOURCE ON THE VEHICLE SIDE Shut off as many following systems and parts as possible since they would generate an electrical load...

Other information:

Toyota Yaris XP210 (2020-2026) Reapir and Service Manual: Inspection

INSPECTION PROCEDURE 1. INSPECT AUTO HIGH BEAM SWITCH (a) Check the resistance. (1) Measure the resistance according to the value(s) in the table below. Standard Resistance: Tester Connection Condition Specified Condition H47-5 (+B) - H47-2 (E) Auto high beam switch off 10 kΩ or higher H47-5 (+B) - H47-2 (E) Auto high beam switch on Below 1 Ω If the result is not as specified, replace the auto high beam switch...

Toyota Yaris XP210 (2020-2026) Reapir and Service Manual: Installation

INSTALLATION PROCEDURE 1. INSTALL FRONT STABILIZER BAR Click here 2. INSTALL STEERING LINK ASSEMBLY Click here 3. TEMPORARILY INSTALL FRONT LOWER NO. 1 SUSPENSION ARM SUB-ASSEMBLY LH (a) Temporarily install the front lower No. 1 suspension arm sub-assembly LH to the front suspension crossmember sub-assembly with the 2 bolts and nut...