Toyota Yaris: Drivetrain / Ea67f (manual Transmission / Transaxle)
INSTALLATION CAUTION / NOTICE / HINT HINT:
Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.
PROCEDURE 1...
ComponentsCOMPONENTS ILLUSTRATION
*1 BACK-UP LIGHT SWITCH ASSEMBLY *2 GASKET *3 NO. 1 ENGINE UNDER COVER ASSEMBLY *4 ENGINE UNDER COVER LH
N*m (kgf*cm, ft...
Other information:
REASSEMBLY PROCEDURE 1. TEMPORARILY TIGHTEN REAR DISC BRAKE BLEEDER PLUG (a) Temporarily tighten the rear disc brake bleeder plug to the rear disc brake cylinder. HINT: Fully tighten the rear disc brake bleeder plug after bleeding the system. 2. INSTALL REAR DISC BRAKE BLEEDER PLUG CAP (a) Install the rear disc brake bleeder plug cap to the rear disc brake bleeder plug...
DESCRIPTION If an ECM that is incompatible with the immobiliser function is installed, the ECM will store this DTC. DTC No. Detection Item DTC Detection Condition Trouble Area Note B279C95 Engine Immobiliser System Incorrect Assembly An ECM that is incompatible with the immobiliser function is installed...
Categories
The front and side supplemental restraint systems (SRS) include different
types of air bags. Please verify the different types of air bags
which are equipped on your vehicle by locating the “SRS AIRBAG”
location indicators. These indicators are visible in the area where the
air bags are installed.
The air bags are installed in the following locations:
The steering wheel hub (driver air bag)
The front passenger dashboard (front passenger air bag)
The outboard sides of the front seatbacks (side air bags)
The front and rear window pillars, and the roof edge along both
sides (curtain air bags)
read more