Toyota Yaris: Ea67f (manual Transmission / Transaxle) / Transmission Control Cable
ComponentsCOMPONENTS ILLUSTRATION
*1 TRANSMISSION REVOLUTION SENSOR *2 O-RING *3 NO. 1 ENGINE UNDER COVER ASSEMBLY - -
N*m (kgf*cm, ft...
Other information:
ON-VEHICLE INSPECTION PROCEDURE 1. INSPECT NO. 1 TURBO PRESSURE SENSOR (a) Check the terminal voltage. (1) Disconnect the No. 1 turbo pressure sensor connector. (2) Turn the ignition switch to ON. (3) Measure the voltage according to the value(s) in the table below...
REASSEMBLY PROCEDURE 1. INSTALL CONTROL SHAFT COVER OIL SEAL (a) Using SST and a hammer, install a control shaft cover oil seal to the control shaft cover. SST: 09307-12010 Drive in Depth: 0 to 0.5 mm (0 to 0.0197 in.)
(b) Coat a new control shaft cover oil seal lip with MP grease...
Categories
Before refueling, close all the doors, windows, and the liftgate/trunk
lid, and switch the ignition OFF.
To open the fuel-filler lid, pull
the remote fuel-filler lid release.

To remove the fuel-filler cap, turn it counterclockwise.
Attach the removed cap to the
inner side of the fuel-filler lid.
read more