Toyota Yaris: Ea67f (manual Transmission / Transaxle) / Shift Lever Assembly
REASSEMBLY PROCEDURE 1. INSTALL CONTROL SHAFT COVER OIL SEAL (a) Using SST and a hammer, install a control shaft cover oil seal to the control shaft cover...
Other information:
MONITOR DESCRIPTION The ECM monitors the signals received from the No. 1 throttle position sensor. As the ECM monitors the VTA1 signal of the No. 1 throttle position sensor, if these signals do not correlate, a DTC will be stored. DTC No. Detection Item DTC Detection Condition Trouble Area MIL Note P060E49 Internal Control Module Throttle Position Performance Internal Electronic Failure Either of the following conditions is met (1 trip detection logic):
ECM main CPU malfunction...
ON-VEHICLE INSPECTION PROCEDURE 1. INSPECT RAIN SENSOR (a) Remove the rain sensor cover. Click here
(b) Disconnect the rain sensor connector. (c) Measure the voltage according to the value(s) in the table below. Standard Voltage: Tester Connection Condition Specified Condition V9-4 (SIG) - V9-2 (ES) Ignition switch ON 11 to 14 V If the result is not as specified, repair or replace the harness or connector...
Categories
The front and side supplemental restraint systems (SRS) include different
types of air bags. Please verify the different types of air bags
which are equipped on your vehicle by locating the “SRS AIRBAG”
location indicators. These indicators are visible in the area where the
air bags are installed.
The air bags are installed in the following locations:
The steering wheel hub (driver air bag)
The front passenger dashboard (front passenger air bag)
The outboard sides of the front seatbacks (side air bags)
The front and rear window pillars, and the roof edge along both
sides (curtain air bags)
read more