Toyota Yaris: Shift Lever Assembly / Components
COMPONENTS
ILLUSTRATION
*1 | FLOOR SHIFT SHIFT LEVER ASSEMBLY | *2 | TRANSMISSION CONTROL CABLE ASSEMBLY |
| N*m (kgf*cm, ft.*lbf): Specified torque | - | - |
REMOVAL PROCEDURE 1. SECURE VEHICLE (a) Fully apply the parking brake and chock a wheel. CAUTION:
Make sure to apply the parking brake and chock a wheel before performing this procedure...
Other information:
COMPONENTS ILLUSTRATION
*1 REAR AXLE HUB AND BEARING ASSEMBLY *2 REAR AXLE SHAFT NUT *3 REAR DISC BRAKE CALIPER ASSEMBLY *4 REAR SPEED SENSOR *5 REAR FLEXIBLE HOSE *6 REAR DRIVE SHAFT ASSEMBLY *7 REAR DISC *8 PARKING BRAKE SHOE ADJUSTING HOLE PLUG
Tightening torque for "Major areas involving basic vehicle performance such as moving/turning/stopping" : N*m (kgf*cm, ft...
DISASSEMBLY CAUTION / NOTICE / HINT NOTICE:
When using a vise, place aluminum plates between the part and vise.
When using a vise, do not overtighten it.
HINT:
Use the same procedure for the RH side and LH side.
The following procedure is for the LH side...
Categories
Stop the vehicle completely.
Manual transaxle:
Shift into neutral and set the parking brake.
Automatic transaxle:
Shift the selector lever to the P position and set the parking brake.
Press the push button start to turn off the engine. The ignition position is
off.
read more