Toyota Yaris: Monolithic Converter / Components

Monolithic Converter

..

Removal

REMOVAL CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during exhaust manifold converter sub-assembly removal/installation are shown below...

Other information:

Toyota Yaris XP210 (2020-2026) Owner's Manual: Indicator Lights

These lights turn on or flash to notify the user of the system operation status or a system malfunction. KEY Indicator Light   Wrench Indicator Light TCS/DSC Indicator Light DSC OFF Indicator Light Low Speed Pre-Collision System Indicator Light Low Speed Pre-Collision System OFF Indicator Light Low Engine Coolant Temperature Indicator Light Shift Position Indication Headlight High-Beam Indicator Light Turn Signal/Hazard Warning Indicator Lights Security Indicator Light Cruise Main Indication Cruise Set Indication/Indicator Light Select Mode Indicator Light Lights-On Indicator Light Front Passenger Air Bag Deactivation Indicator Light * 1: The light turns on when the ignition is switched on for an operation check, and turns off a few seconds later or when the engine is started...

Toyota Yaris XP210 (2020-2026) Reapir and Service Manual: Reassembly

REASSEMBLY PROCEDURE 1. INSTALL GENERATOR DRIVE END FRAME BEARING (a) Using SST and a press, install a new generator drive end frame bearing. SST: 09950-60011 09951-00470 SST: 09950-70010 09951-07100 (b) Fit the tabs of the retainer plate into the cutouts of the generator drive end frame to install the retainer plate...