Toyota Yaris: Meters and Gauges / Fuel Gauge

Toyota Yaris XP210 (2020-2026) Owner's Manual / When Driving / Combination Meter and Display / Meters and Gauges / Fuel Gauge

The fuel gauge shows approximately how much fuel is remaining in the tank when the ignition is switched ON. We recommend keeping the tank over 1/4 full.

Toyota Yaris. Fuel Gauge

Full
1/4 Full
Empty

If the low fuel warning light illuminates or the fuel level is very low, refuel as soon as possible.

If inconsistency in engine performance or stalling occurs due to low fuel level conditions, refuel the vehicle as soon as possible and add at least 10 L (2.7 US gal, 2.2 Imp gal) of fuel. Refer to Warning/Indicator Lights.

After refueling, it may require some time for the indicator to stabilize. In addition, the indicator may deviate while driving on a slope or curve since the fuel moves in the tank.
The display indicating a quarter or less remaining fuel has more segments to show the remaining fuel level in greater detail.
The direction of the arrow ( ) indicates that the fuel-filler lid is on the left side of the vehicle.

Speedometer, Odometer, Trip Meter and Trip Meter Selector

Speedometer The speedometer indicates the speed of the vehicle. If a few seconds have elapsed after switching the ignition off, the needle may deviate...

Dashboard Illumination

When the position lights are turned on with the ignition switched ON, the brightness of the instrument panel illumination is dimmed. When the position lights are turned on, the position lights indicator light in the combination meter turns on...

Other information:

Toyota Yaris XP210 (2020-2026) Reapir and Service Manual: Stop and Start Priority Control System

DESCRIPTION In stop and start control status, there is normal status (Standard) and stop and start priority status (Extended). Stop and start control status can be switched to the desired mode by pressing and holding the stop and start system cancel switch (combination switch assembly), or by operating the steering pad switch assembly, and the mode change is also shown on the multi-information display screen...

Toyota Yaris XP210 (2020-2026) Reapir and Service Manual: On-vehicle Inspection

ON-VEHICLE INSPECTION PROCEDURE 1. CONNECT GTS (a) Connect the GTS to the DLC3 with the engine switch off. (b) Start the engine and run it at idle. (c) Turn the GTS on. (d) Enter the following menus: Chassis / Brake/EPB / Active Test. HINT: Refer to the GTS operator's manual for further details...