Toyota Yaris: When Driving / Combination Meter and Display

Turning the Engine Off

Stop the vehicle completely. Manual transaxle: Shift into neutral and set the parking brake.Automatic transaxle: Shift the selector lever to the P position and set the parking brake...

Meters and Gauges

C..

Other information:

Toyota Yaris XP210 (2020-2026) Reapir and Service Manual: Front Floor Electrical Key Oscillator Circuit Open (B27A513)

DESCRIPTION The certification ECU (smart key ECU assembly) generates a request signal and transmits the signal to the No. 1 indoor electrical key antenna assembly (front floor). For the No. 1 indoor electrical key antenna assembly (front floor) to detect when the electrical key transmitter sub-assembly is in the cabin, the signal from the certification ECU (smart key ECU assembly) requesting a response from the electrical key transmitter sub-assembly is transmitted inside the vehicle...

Toyota Yaris XP210 (2020-2026) Reapir and Service Manual: Terminals Of Ecu

TERMINALS OF ECU COMBINATION METER ASSEMBLY (a) Measure the voltage and resistance and check for pulses according to the value(s) in the table below. Terminal No. (Symbol) Terminal Description Condition Specified Condition H6-1 (B) - Body ground Auxiliary battery Ignition switch off 11 to 14 V H6-9 (CANH) CAN communication line - - H6-10 (MSCL) Local bus communication line - - H6-11 (TX1-) - Body ground Outside temperature sensor signal - - H6-13 (FR2) - H6-24 (FE&B) Fuel level signal Ignition switch ON, fuel level full → low (fuel level warning light on) Pulse generation (See waveform 3) H6-14 (FV) - Body ground Fuel sender gauge (Power source) Ignition switch ON Pulse generation (See waveform 1) H6-15 (MSTI) - Body ground Steering pad switch signal Ignition switch ON, up, down, right and left switches on steering pad switch not pushed 4...