Toyota Yaris: Engine & Hybrid System / G16e-gts (engine Mechanical)

Toyota Yaris XP210 (2020-2024) Reapir and Service Manual / Engine & Hybrid System / G16e-gts (engine Mechanical)

Vacuum Sensor

ComponentsCOMPONENTS ILLUSTRATION *1 E.F.I. VACUUM SENSOR ASSEMBLY *2 VACUUM HOSE *3 NO. 1 ENGINE COVER SUB-ASSEMBLY - - N*m (kgf*cm, ft...

Other information:

Toyota Yaris XP210 (2020-2024) Reapir and Service Manual: Fuel Receiver Gauge Malfunction

DESCRIPTION FUEL RECEIVER GAUGE OPERATION (a) OPERATION The combination meter assembly uses the fuel sender gauge assembly to detect the amount of fuel remaining in the fuel tank assembly. The Hall IC built into the fuel sender gauge assembly changes the output voltage according to the amount of fuel remaining...

Toyota Yaris XP210 (2020-2024) Reapir and Service Manual: Intake Air Temperature Sensor 1 Bank 1 Circuit Short to Battery or Open (P011015)

DESCRIPTION Refer to DTC P011011. Click here HINT: When DTC P011015 is stored, the ECM enters fail-safe mode. During fail-safe mode, the intake air temperature is estimated to be 20°C (68°F) by the ECM. Fail-safe mode continues until a pass condition is detected, and the ignition switch is then turned off...

Categories

Supplemental Restraint System (SRS) Precautions

The front and side supplemental restraint systems (SRS) include different types of air bags. Please verify the different types of air bags which are equipped on your vehicle by locating the “SRS AIRBAG” location indicators. These indicators are visible in the area where the air bags are installed.

The air bags are installed in the following locations:

The steering wheel hub (driver air bag) The front passenger dashboard (front passenger air bag) The outboard sides of the front seatbacks (side air bags) The front and rear window pillars, and the roof edge along both sides (curtain air bags)