Toyota Yaris: G16e-gts (engine Mechanical) / Engine
ComponentsCOMPONENTS ILLUSTRATION
*1 FAN AND GENERATOR V BELT *2 ENGINE UNDER COVER RH *3 NO. 1 ENGINE UNDER COVER ASSEMBLY - -
N*m (kgf*cm, ft...
ON-VEHICLE INSPECTION CAUTION / NOTICE / HINT CAUTION:
When working near the engine room while the engine has started or the power source mode is engine switch on (IG), do not touch the fan and generator V belt or rotating components such as the fan, etc...
Other information:
INSTALLATION PROCEDURE 1. INSTALL FUEL MAIN VALVE ASSEMBLY (a) Apply gasoline to a new O-ring. (b) Install the spacer and O-ring to the fuel main valve assembly.
*1 O-ring *2 Spacer (c) Install the fuel main valve assembly to the fuel suction with pump and gauge tube assembly...
PROBLEM SYMPTOMS TABLE If there are no DTCs output and the problem still occurs, check the suspected areas for each problem symptom in the order given in the following table and proceed to the relevant troubleshooting page. NOTICE: When replacing the skid control ECU (brake actuator assembly), sensors, etc...
Categories
WARNING
When removing the fuel-filler cap, loosen the cap slightly and wait
for
any hissing to stop, then remove it
Fuel spray is dangerous. Fuel can burn skin and eyes and cause illness
if
ingested. Fuel spray is released when there is pressure in the fuel tank and
the fuel-filler cap is removed too quickly.
read more