Toyota Yaris: G16e-gts (engine Mechanical) / Balanceshaft

G16e-gts (engine Mechanical)

..

On-vehicle Inspection

ON-VEHICLE INSPECTION PROCEDURE 1. REMOVE NO. 1 ENGINE UNDER COVER ASSEMBLY Click here 2. DRAIN ENGINE OIL Click here 3. DRAIN ENGINE COOLANT Click here 4...

Other information:

Toyota Yaris XP210 (2020-2026) Reapir and Service Manual: After Engine Stops due to Stop and Start System, Engine does not Restart

DESCRIPTION This is the troubleshooting procedure for situations where the engine does not restart after having been stopped by the stop and start system. For information on stop and start control, refer to the system description. Click here CAUTION / NOTICE / HINT PRECAUTIONS WHEN THE ENGINE STOP AND START ECU AND THE STARTER ASSEMBLY ARE REPLACED NOTICE: When the engine stop and start ECU is replaced, it is necessary to read the number of starter operations before replacement and store this number in the new engine stop and start ECU after replacement, and to perform external backup boost converter (eco run vehicle converter assembly) existence learning...

Toyota Yaris XP210 (2020-2026) Reapir and Service Manual: Removal

REMOVAL PROCEDURE 1. DISCONNECT NO. 1 ROOF HEADLINING MOULDING LH Click here 2. DISCONNECT NO. 1 ROOF HEADLINING MOULDING RH HINT: Use the same procedure as for the LH side. 3. REMOVE FRONT PILLAR GARNISH LH Click here 4. REMOVE FRONT PILLAR GARNISH RH HINT: Use the same procedure as for the LH side...