Toyota Yaris: G16e-gts (engine Mechanical) / Cylinder Head Gasket
REPAIR PROCEDURE 1. REPAIR INTAKE VALVE SEAT NOTICE:
While repairing the intake valve seat, make sure to constantly check the valve seat width and valve seating position...
COMPONENTS ILLUSTRATION
*1 NO. 1 VALVE ROCKER ARM SUB-ASSEMBLY *2 VALVE LASH ADJUSTER ASSEMBLY *3 VALVE STEM CAP *4 CYLINDER HEAD SUB-ASSEMBLY *5 CYLINDER HEAD GASKET *6 CYLINDER HEAD SET BOLT *7 NO...
Other information:
INSTALLATION PROCEDURE 1. INSTALL VACUUM PUMP ASSEMBLY (a) When using new vacuum pump assembly: (1) Apply engine oil to the No. 4 O-ring installed in a new vacuum pump assembly. NOTICE: Do not apply engine oil to the No. 2 O-ring.
*1 No. 2 O-ring *2 No...
CALIBRATION DESCRIPTION (a) Refer to the table below and then perform the necessary operation according to the part to be replaced in order to perform calibration. Parts to be Replaced / Operation Necessary Operation Skid control ECU (brake actuator assembly) Calibration Yaw rate and acceleration sensor (airbag sensor assembly) Calibration Wheel alignment adjustment Calibration UTILITY ITEMS Utility Items Main Purpose Link All Readiness Confirm if DTC judgment has been completed...
Categories
The front seat belt pretensioners are designed to deploy in moderate or
severe frontal, near frontal collisions.
In addition, the pretensioners operate when a side collision or a rollover
accident is detected. The pretensioners operate differently
depending on what types of air bags are equipped. For more details
about the seat belt pretensioner operation, refer to the SRS Air Bag
Deployment Criteria.
read more