Toyota Yaris: G16e-gts (engine Mechanical) / Camshaft

On-vehicle Inspection

ON-VEHICLE INSPECTION PROCEDURE 1. REMOVE NO. 1 ENGINE UNDER COVER ASSEMBLY Click here 2. DRAIN ENGINE OIL Click here 3. DRAIN ENGINE COOLANT Click here 4...

Components

COMPONENTS ILLUSTRATION *1 SPARK PLUG *2 OIL PRESSURE AND TEMPERATURE SENSOR *3 CAMSHAFT POSITION SENSOR (for Intake Side) *4 CAMSHAFT POSITION SENSOR (for Exhaust Side) *5 CAM TIMING OIL CONTROL SOLENOID ASSEMBLY (for Intake Side) *6 CAM TIMING OIL CONTROL SOLENOID ASSEMBLY (for Exhaust Side) *7 WATER INLET WITH THERMOSTAT SUB-ASSEMBLY *8 WATER INLET WITH WATER PUMP HOUSING SUB-ASSEMBLY *9 OIL FILLER CAP ASSEMBLY *10 O-RING *11 CRANKSHAFT POSITION SENSOR *12 PCV VALVE (VENTILATION VALVE SUB-ASSEMBLY) *13 VACUUM PUMP ASSEMBLY *14 GASKET *15 NO...

Other information:

Toyota Yaris XP210 (2020-2026) Reapir and Service Manual: Removal

REMOVAL CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during exhaust manifold removal/installation are shown below. Necessary Procedures After Parts Removed/Installed/Replaced Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link Gas leak from exhaust system is repaired Inspection After Repair Poor idle, etc...

Toyota Yaris XP210 (2020-2026) Reapir and Service Manual: ABS Warning Light Remains ON

DESCRIPTION This procedure is for troubleshooting when the ABS warning light remains on but no DTCs are output. The skid control ECU (brake actuator assembly) controls the ABS warning light in the combination meter assembly via CAN communication. CAUTION / NOTICE / HINT NOTICE: After replacing the skid control ECU (brake actuator assembly), perform "Calibration"...