Toyota Yaris: Ea67f (manual Transmission / Transaxle) / Input Shaft
REPLACEMENT CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during the transaxle case oil seal and front dirve shaft oil seal RH removal/installation are shown below...
Other information:
ComponentsCOMPONENTS ILLUSTRATION
*1 LICENSE PLATE LIGHT LENS *2 LICENSE PLATE LIGHT BULB RemovalREMOVAL CAUTION / NOTICE / HINT HINT:
Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
PROCEDURE 1...
REASSEMBLY PROCEDURE 1. INSTALL CONTROL SHAFT COVER OIL SEAL (a) Using SST and a hammer, install a control shaft cover oil seal to the control shaft cover. SST: 09307-12010 Drive in Depth: 0 to 0.5 mm (0 to 0.0197 in.)
(b) Coat a new control shaft cover oil seal lip with MP grease...
Categories
Stop the vehicle completely.
Manual transaxle:
Shift into neutral and set the parking brake.
Automatic transaxle:
Shift the selector lever to the P position and set the parking brake.
Press the push button start to turn off the engine. The ignition position is
off.
read more