Toyota Yaris: Ea67f (manual Transmission / Transaxle) / Shift And Select Lever Shaft

Reassembly

REASSEMBLY PROCEDURE 1. INSTALL NEEDLE ROLLER BEARING (a) Coat the needle roller bearing with gear oil and install it to the No. 2 output shaft. 2...

Components

COMPONENTS ILLUSTRATION *1 SHIFT AND SELECT LEVER ASSEMBLY *2 NO. 1 SELECTING BELL CRANK DUST COVER *3 SELECTING BELL CRANK ASSEMBLY *4 CONTROL SHIFT LEVER BUSHING *5 SHIFT GATE PIN *6 NO...

Other information:

Toyota Yaris XP210 (2020-2026) Reapir and Service Manual: Terminals Of Ecu

TERMINALS OF ECU CHECK CERTIFICATION ECU (SMART KEY ECU ASSEMBLY) (a) Disconnect the H46 certification ECU (smart key ECU assembly) connector. (b) Measure the voltage and resistance according to the value(s) in the table below. Tester Connection Terminal Description Condition Specified Condition Related Data List Item H46-29 (E) - Body ground Ground Always Below 1 Ω - H46-6 (+B) - H46-29 (E) Power supply Always 11 to 14 V - H45-22 (CUTB) - H46-29 (E) Dark current cut pin* Ignition switch off 11 to 14 V - *: In order to prevent the vehicle auxiliary battery from being depleted when the vehicle is shipped long distances, a fuse that cuts unnecessary electrical load while the vehicle is being shipped is installed in the circuit...

Toyota Yaris XP210 (2020-2026) Reapir and Service Manual: Engine Oil Pressure Sensor/Switch "A" Signal Stuck High (P052024,P05202A)

DESCRIPTION Refer to DTC P052012. Click here DTC No. Detection Item DTC Detection Condition Trouble Area MIL Note P052024 Engine Oil Pressure Sensor/Switch "A" Signal Stuck High The oil pressure sensor output voltage is higher than the threshold value (1 trip detection logic)...