Toyota Yaris: Ea67f (manual Transmission / Transaxle) / Output Shaft
ComponentsCOMPONENTS ILLUSTRATION
*1 NEUTRAL POSITION SWITCH *2 GASKET *3 NO. 1 ENGINE UNDER COVER ASSEMBLY *4 ENGINE UNDER COVER LH
N*m (kgf*cm, ft...
COMPONENTS ILLUSTRATION
*1 OUTPUT SHAFT BEARING SHAFT SNAP RING *2 NEEDLE ROLLER BEARING *3 SYNCHRONIZER SHIFTING KEY SPRING *4 SHAFT SNAP RING *5 SPACER *6 BALL *7 OUTPUT SHAFT FRONT BEARING INNER RACE *8 SYNCHROMESH SHIFTING KEY BALL *9 NO...
Other information:
ON-VEHICLE INSPECTION PROCEDURE 1. INSPECT NO. 1 TURBO PRESSURE SENSOR (a) Check the terminal voltage. (1) Disconnect the No. 1 turbo pressure sensor connector. (2) Turn the ignition switch to ON. (3) Measure the voltage according to the value(s) in the table below...
COMPONENTS ILLUSTRATION
*1 NO. 1 ENGINE UNDER COVER ASSEMBLY *2 ENGINE UNDER COVER LH *3 ENGINE UNDER COVER RH - -
N*m (kgf*cm, ft.*lbf): Specified torque - - ILLUSTRATION
*1 FRONT AXLE SHAFT NUT *2 FRONT SPEED SENSOR *3 FRONT FLEXIBLE HOSE *4 STEERING KNUCKLE SEAL *5 COTTER PIN *6 TIE ROD END SUB-ASSEMBLY *7 FRONT STABILIZER LINK ASSEMBLY *8 FRONT LOWER NO...
Categories
Stop the vehicle completely.
Manual transaxle:
Shift into neutral and set the parking brake.
Automatic transaxle:
Shift the selector lever to the P position and set the parking brake.
Press the push button start to turn off the engine. The ignition position is
off.
read more