Toyota Yaris: Ea67f (manual Transmission / Transaxle) / Differential Oil Seal (for Rh Side)
ComponentsCOMPONENTS ILLUSTRATION
*1 FRONT DRIVE SHAFT OIL SEAL LH - - ● Non-reusable part
MP grease ReplacementREPLACEMENT CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during the front drive shaft oil seal LH removal/installation are shown below...
COMPONENTS ILLUSTRATION
*1 DRIVE SHAFT BEARING BRACKET *2 FRONT DRIVE SHAFT OIL SEAL RH *3 TRANSAXLE CASE OIL SEAL *4 MANUAL TRANSAXLE ASSEMBLY
Tightening torque for "Major areas involving basic vehicle performance such as moving/turning/stopping": N*m (kgf*cm, ft...
Other information:
INSTALLATION CAUTION / NOTICE / HINT HINT:
Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.
PROCEDURE 1. INSTALL FRONT DISC (a) Check the identification marks and confirm the installation positions...
REASSEMBLY PROCEDURE 1. INSTALL CONTROL SHAFT COVER OIL SEAL (a) Using SST and a hammer, install a control shaft cover oil seal to the control shaft cover. SST: 09307-12010 Drive in Depth: 0 to 0.5 mm (0 to 0.0197 in.)
(b) Coat a new control shaft cover oil seal lip with MP grease...
Categories
The fuel gauge shows approximately how much fuel is remaining in
the tank when the ignition is switched ON. We recommend keeping
the tank over 1/4 full.

Full
1/4 Full
Empty
read more