Toyota Yaris: Ea67f (manual Transmission / Transaxle) / Manual Transaxle Unit

Pattern Select Switch iMT Mode Circuit

DESCRIPTION Operating the iMT switch illuminates the iMT indicator light in the combination meter assembly. This displays the iMT system standby condition...

Components

COMPONENTS ILLUSTRATION *1 SHIFT GATE PIN *2 NO. 2 LOCK BALL ASSEMBLY *3 NO. 1 LOCK BALL ASSEMBLY *4 TRANSMISSION REVOLUTION SENSOR *5 TEMPERATURE SENSOR *6 NEUTRAL POSITION SWITCH *7 BACK-UP LAMP SWITCH ASSEMBLY *8 SELECTING BELL CRANK ASSEMBLY *9 CONTROL CABLE BRACKET *10 CLUTCH RELEASE CYLINDER WITH BEARING ASSEMBLY *11 CLUTCH TUBE BOOT *12 BLEEDER CLUTCH RELEASE TUBE *13 CLUTCH RELEASE BLEEDER SUB-ASSEMBLY *14 CLUTCH RELEASE BEARING PLATE *15 RELEASE CYLINDER BLEEDER PLUG *16 RELEASE CYLINDER BLEEDER PLUG CAP *17 NO...

Other information:

Toyota Yaris XP210 (2020-2026) Reapir and Service Manual: Active Noise Control Microphone

ComponentsCOMPONENTS ILLUSTRATION *1 ACTIVE NOISE CONTROL MICROPHONE - - RemovalREMOVAL CAUTION / NOTICE / HINT HINT: When the cable is disconnected / reconnected to the auxiliary battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used...

Toyota Yaris XP210 (2020-2026) Reapir and Service Manual: On-vehicle Inspection

ON-VEHICLE INSPECTION PROCEDURE 1. CHECK FUEL PUMP OPERATION AND INSPECT FOR FUEL LEAK (a) Check fuel pump operation. (1) Connect the GTS to the DLC3. (2) Turn the ignition switch to ON. NOTICE: Do not start the engine. (3) Turn the GTS on. (4) Enter the following menus: Powertrain / Engine / Active Test / Activate the Circuit Relay...