Toyota Yaris: Vehicle Exterior / Exterior Panels / Trim
INSTALLATION PROCEDURE 1. INSTALL HOOD LOCK CONTROL CABLE ASSEMBLY (a) Pass the hood lock control cable assembly into the engine compartment. (b) Engage the grommet...
Other information:
INSPECTION PROCEDURE 1. INSPECT FRONT SEATBACK HEATER ASSEMBLY LH (a) Check the resistance. (1) Measure the resistance according to the value(s) in the table below. Standard Resistance: Tester Connection Condition Specified Condition
If the result is not as specified, replace the front seatback heater assembly LH...
PARTS LOCATION ILLUSTRATION
*1 FRONT AIRBAG SENSOR LH *2 FRONT AIRBAG SENSOR RH *3 SIDE AIRBAG PRESSURE SENSOR LH *4 SIDE AIRBAG PRESSURE SENSOR RH *5 NO. 1 SIDE AIRBAG SENSOR LH *6 NO. 1 SIDE AIRBAG SENSOR RH ILLUSTRATION
*1 FRONT SEAT OUTER BELT ASSEMBLY LH *2 FRONT SEAT OUTER BELT ASSEMBLY RH *3 CURTAIN SHIELD AIRBAG ASSEMBLY LH *4 CURTAIN SHIELD AIRBAG ASSEMBLY RH ILLUSTRATION
*1 AIRBAG SENSOR ASSEMBLY *2 HORN BUTTON ASSEMBLY *3 SPIRAL CABLE SUB-ASSEMBLY *4 INSTRUMENT PANEL PASSENGER WITHOUT DOOR AIRBAG ASSEMBLY *5 FRONT SEAT AIRBAG ASSEMBLY LH *6 FRONT SEAT AIRBAG ASSEMBLY RH *7 TELLTALE LIGHT ASSEMBLY - PASSENGER AIRBAG ON/OFF INDICATOR *8 AIRBAG CUT OFF SWITCH CYLINDER SUB-ASSEMBLY *9 COMBINATION METER ASSEMBLY - SRS WARNING LIGHT *10 DLC3 *11 POWER DISTRIBUTION BOX ASSEMBLY - A/BAG-IGR FUSE - ECU-IGR NO...
Categories
Before refueling, close all the doors, windows, and the liftgate/trunk
lid, and switch the ignition OFF.
To open the fuel-filler lid, pull
the remote fuel-filler lid release.

To remove the fuel-filler cap, turn it counterclockwise.
Attach the removed cap to the
inner side of the fuel-filler lid.
read more