Toyota Yaris: Exterior Panels / Trim / Rear Spoiler
INSTALLATION PROCEDURE 1. INSTALL REAR BUMPER ASSEMBLY (a) Connect the connector.
Install in the Direction (b) Engage the claws to install the rear bumper assembly as shown in the illustration...
COMPONENTS ILLUSTRATION
*1 REAR SPOILER ASSEMBLY *2 REAR SPOILER HOLE COVER *3 CENTER STOP LIGHT COVER - -
N*m (kgf*cm, ft...
Other information:
ComponentsCOMPONENTS ILLUSTRATION
*1 TRANSMISSION REVOLUTION SENSOR *2 O-RING *3 NO. 1 ENGINE UNDER COVER ASSEMBLY - -
N*m (kgf*cm, ft.*lbf): Specified torque ● Non-reusable part
Toyota Genuine Adhesive 1324, Three Bond 1324 or equivalent
Gear oil ★ Precoated part - - RemovalREMOVAL PROCEDURE 1...
DESCRIPTION The SRS warning light is located in the combination meter assembly. When the SRS is normal, the SRS warning light comes on for approximately 6 seconds after the ignition switch is turned from off to ON, and then turns off automatically. If there is a malfunction in the SRS, the SRS warning light comes on to inform the driver of a problem...
Categories
Stop the vehicle completely.
Manual transaxle:
Shift into neutral and set the parking brake.
Automatic transaxle:
Shift the selector lever to the P position and set the parking brake.
Press the push button start to turn off the engine. The ignition position is
off.
read more