Toyota Yaris: Exterior Panels / Trim / Roof Drip Side Finish Moulding

Toyota Yaris XP210 (2020-2026) Reapir and Service Manual / Vehicle Exterior / Exterior Panels / Trim / Roof Drip Side Finish Moulding

Rocker Panel Moulding

ComponentsCOMPONENTS ILLUSTRATION *1 ROCKER PANEL MOULDING - - RemovalREMOVAL CAUTION / NOTICE / HINT HINT: Use the same procedure for the RH side and LH side...

Other information:

Toyota Yaris XP210 (2020-2026) Reapir and Service Manual: Removal

REMOVAL PROCEDURE 1. SEPARATE ENGINE WIRE (a) Remove the bolt and engine wire. 2. REMOVE IGNITION COIL ASSEMBLY (a) Disconnect the ignition coil assembly connector. (b) Remove the bolt and ignition coil assembly. 3. REMOVE CAMSHAFT POSITION SENSOR (for Intake Side) (a) Disconnect the camshaft position sensor connector...

Toyota Yaris XP210 (2020-2026) Reapir and Service Manual: Installation

INSTALLATION CAUTION / NOTICE / HINT HINT: Use the same procedure for the RH and LH sides. The procedure listed below is for the LH side. PROCEDURE 1. INSTALL REAR COMBINATION LIGHT ASSEMBLY (a) Connect the 3 connectors and engage the clamp...

Categories

Break-In Period

No special break-in is necessary, but a few precautions in the first 600 miles (1,000 km) may add to the performance, economy, and life of the vehicle.

Do not race the engine. Do not maintain one constant speed, either slow or fast, for a long period of time. Do not drive constantly at full-throttle or high engine rpm for extended periods of time. Avoid unnecessary hard stops. Avoid full-throttle starts.