Toyota Yaris: Exterior Panels / Trim / Front Bumper
INSTALLATION PROCEDURE 1. INSTALL BACK DOOR OUTSIDE GARNISH SUB-ASSEMBLY (a) Engage the clips to install the back door outside garnish sub-assembly as shown in the illustration...
COMPONENTS ILLUSTRATION
*1 FRONT BUMPER ASSEMBLY *2 PIN HOLD CLIP ILLUSTRATION
*A w/ Pre-collision System - - *1 NO. 3 ENGINE ROOM WIRE *2 MILLIMETER WAVE RADAR SENSOR ASSEMBLY
N*m (kgf*cm, ft...
Other information:
INSTALLATION PROCEDURE 1. INSTALL FLOOR SHIFT SHIFT LEVER ASSEMBLY (a) Install the floor shift shift lever assembly to the vehicle body with the 4 bolts. Torque: 12 N·m {122 kgf·cm, 9 ft·lbf} (b) Engage the 4 clamps to connect the wire harness to the floor shift shift lever assembly...
TERMINALS OF ECU
*1 Power Distribution Box Assembly *2 Main Body ECU (Multiplex Network Body ECU) CHECK MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU) AND POWER DISTRIBUTION BOX ASSEMBLY (a) Remove the main body ECU (multiplex network body ECU) from the power distribution box assembly...
Categories
The front seat belt pretensioners are designed to deploy in moderate or
severe frontal, near frontal collisions.
In addition, the pretensioners operate when a side collision or a rollover
accident is detected. The pretensioners operate differently
depending on what types of air bags are equipped. For more details
about the seat belt pretensioner operation, refer to the SRS Air Bag
Deployment Criteria.
read more