Toyota Yaris: Exterior Panels / Trim / Rear Bumper
REMOVAL CAUTION / NOTICE / HINT HINT: When removing the name plates, heat the vehicle body, back door outside garnish and name plates using a heat light...
COMPONENTS ILLUSTRATION
*1 REAR BUMPER SIDE SEAL RH *2 REAR BUMPER SIDE SEAL LH *3 REAR BUMPER ASSEMBLY - - ILLUSTRATION
*1 BACK-UP LIGHT ASSEMBLY *2 NO...
Other information:
INSPECTION PROCEDURE 1. INSTALL OUTER MIRROR SWITCH ASSEMBLY (a) Check the mirror select and surface adjust switch. (1) Turn the mirror select and surface adjust switch to the L position.
*a Mirror Select and Surface Adjust Switch *b Component without harness connected (Outer Mirror Switch Assembly) (2) Measure the resistance according to the value(s) in the table below...
ON-VEHICLE INSPECTION PROCEDURE 1. INSPECT RAIN SENSOR (a) Remove the rain sensor cover. Click here
(b) Disconnect the rain sensor connector. (c) Measure the voltage according to the value(s) in the table below. Standard Voltage: Tester Connection Condition Specified Condition V9-4 (SIG) - V9-2 (ES) Ignition switch ON 11 to 14 V If the result is not as specified, repair or replace the harness or connector...
Categories
Before refueling, close all the doors, windows, and the liftgate/trunk
lid, and switch the ignition OFF.
To open the fuel-filler lid, pull
the remote fuel-filler lid release.

To remove the fuel-filler cap, turn it counterclockwise.
Attach the removed cap to the
inner side of the fuel-filler lid.
read more