Toyota Yaris: Exterior Panels / Trim / Windshield Outside Moulding

Toyota Yaris XP210 (2020-2026) Reapir and Service Manual / Vehicle Exterior / Exterior Panels / Trim / Windshield Outside Moulding

Tail Gate Protector

ComponentsCOMPONENTS ILLUSTRATION *1 ROOF TOP MOULDING SUB-ASSEMBLY - - RemovalREMOVAL PROCEDURE 1. REMOVE ROOF HEADLINING Click here 2...

Other information:

Toyota Yaris XP210 (2020-2026) Reapir and Service Manual: Installation

INSTALLATION CAUTION / NOTICE / HINT HINT: Use the same procedure for the RH side and LH side. The following procedure is for the LH side. PROCEDURE 1. INSTALL REAR DRIVE SHAFT INBOARD JOINT SHAFT SNAP RING (a) Install a new rear drive shaft inboard joint shaft snap ring to the rear drive shaft assembly...

Toyota Yaris XP210 (2020-2026) Reapir and Service Manual: Stop and Start Priority Control System

DESCRIPTION In stop and start control status, there is normal status (Standard) and stop and start priority status (Extended). Stop and start control status can be switched to the desired mode by pressing and holding the stop and start system cancel switch (combination switch assembly), or by operating the steering pad switch assembly, and the mode change is also shown on the multi-information display screen...

Categories

Break-In Period

No special break-in is necessary, but a few precautions in the first 600 miles (1,000 km) may add to the performance, economy, and life of the vehicle.

Do not race the engine. Do not maintain one constant speed, either slow or fast, for a long period of time. Do not drive constantly at full-throttle or high engine rpm for extended periods of time. Avoid unnecessary hard stops. Avoid full-throttle starts.