Toyota Yaris: Brake / Brake (front)
Other information:
REMOVAL PROCEDURE 1. REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY Click here
2. REMOVE CLUTCH START SWITCH ASSEMBLY Click here
3. REMOVE CLUTCH MASTER CYLINDER PUSH ROD CLEVIS WITH HOLE PIN (a) Remove the clip from the clevis pin.
(b) Remove the master cylinder push rod clevis with hole pin to disconnect the clutch master cylinder assembly from the clutch pedal sub-assembly...
PARTS LOCATION ILLUSTRATION
*1 ECM *2 NO. 1 ENGINE ROOM RELAY BLOCK - ECU-IGP NO. 3 FUSE ILLUSTRATION
*1 STEREO COMPONENT EQUALIZER ASSEMBLY *2 DLC3 ILLUSTRATION
*1 ACTIVE NOISE CONTROL MICROPHONE LH *2 ACTIVE NOISE CONTROL MICROPHONE RH *3 FRONT NO...
Categories
No special break-in is necessary, but a few precautions in the first 600
miles (1,000 km) may add to the performance, economy, and life of
the vehicle.
Do not race the engine.
Do not maintain one constant speed, either slow or fast, for a long
period of time.
Do not drive constantly at full-throttle or high engine rpm for
extended periods of time.
Avoid unnecessary hard stops.
Avoid full-throttle starts.
read more