Toyota Yaris: Brake (front) / Front Brake
COMPONENTS ILLUSTRATION
*1 FRONT DISC BRAKE PIN HOLD CLIP *2 FRONT DISC BRAKE ANTI-RATTLE PIN *3 FRONT DISC BRAKE ANTI-RATTLE SPRING *4 FRONT DISC BRAKE PAD *5 FRONT DISC BRAKE ANTI-SQUEAL SHIM - - ILLUSTRATION
*1 FRONT FLEXIBLE HOSE *2 UNION BOLT *3 GASKET *4 FRONT DISC BRAKE CYLINDER ASSEMBLY *5 FRONT DISC - -
Tightening torque for "Major areas involving basic vehicle performance such as moving/turning/stopping": N*m (kgf*cm, ft...
Other information:
DISASSEMBLY CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during cylinder head removal/installation are shown below...
On-vehicle InspectionON-VEHICLE INSPECTION PROCEDURE 1. INSPECT HORN RELAY ASSEMBLY (a) Check the resistance. (1) Measure the resistance according to the value(s) in the table below. Standard Resistance: Tester Connection Condition Specified Condition 3 - 5 Auxiliary battery voltage not applied between terminals 1 and 2 10 kΩ or higher 3 - 5 Auxiliary battery voltage applied between terminals 1 and 2 Below 1 Ω If the result is not as specified, replace the horn relay assembly...
Categories
The front and side supplemental restraint systems (SRS) include different
types of air bags. Please verify the different types of air bags
which are equipped on your vehicle by locating the “SRS AIRBAG”
location indicators. These indicators are visible in the area where the
air bags are installed.
The air bags are installed in the following locations:
The steering wheel hub (driver air bag)
The front passenger dashboard (front passenger air bag)
The outboard sides of the front seatbacks (side air bags)
The front and rear window pillars, and the roof edge along both
sides (curtain air bags)
read more