Toyota Yaris: Brake
INSTALLATION PROCEDURE 1. INSTALL ROOF ANTENNA ASSEMBLY (a) When reusing the roof antenna assembly: (1) Install a new seal.
(b) Engage the guides and claws to install the roof antenna assembly to the antenna cover as shown in the illustration...
Other information:
REMOVAL CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during rear suspension member sub-assembly removal/installation are shown below...
REMOVAL CAUTION / NOTICE / HINT HINT:
Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
PROCEDURE 1. REMOVE BACK DOOR TRIM BOARD Click here
2. REMOVE BACK DOOR TRIM COVER Click here
3. REMOVE LICENSE PLATE LIGHT ASSEMBLY (a) Disconnect the connector...
Categories
The fuel gauge shows approximately how much fuel is remaining in
the tank when the ignition is switched ON. We recommend keeping
the tank over 1/4 full.

Full
1/4 Full
Empty
read more