Toyota Yaris: Brake System (other) / Brake Booster
ON-VEHICLE INSPECTION PROCEDURE 1. INSPECT BRAKE BOOSTER ASSEMBLY (a) Airtightness check (1) Start the engine and stop it after 1 or 2 minutes. Slowly depress the brake pedal several times...
Other information:
DESCRIPTION DTC No. Detection Item DTC Detection Condition Trouble Area Warning Indicate Test Mode / Check Mode B00011A Driver Frontal Stage 1 Deployment Control Circuit Resistance Below Threshold
The airbag sensor assembly detects a line short in the driver seat airbag squib circuit for 2 seconds during the primary check
Spiral cable sub-assembly malfunction
Horn button assembly malfunction
Airbag sensor assembly malfunction
Harness or connector
Spiral cable sub-assembly
Horn button assembly
Airbag sensor assembly
Comes on Applies to check mode WIRING DIAGRAM
CAUTION / NOTICE / HINT NOTICE: After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal...
COMPONENTS ILLUSTRATION
*1 SPARK PLUG *2 OIL PRESSURE AND TEMPERATURE SENSOR *3 CAMSHAFT POSITION SENSOR (for Intake Side) *4 CAMSHAFT POSITION SENSOR (for Exhaust Side) *5 CAM TIMING OIL CONTROL SOLENOID ASSEMBLY (for Intake Side) *6 CAM TIMING OIL CONTROL SOLENOID ASSEMBLY (for Exhaust Side) *7 WATER INLET WITH THERMOSTAT SUB-ASSEMBLY *8 WATER INLET WITH WATER PUMP HOUSING SUB-ASSEMBLY *9 OIL FILLER CAP ASSEMBLY *10 O-RING *11 CRANKSHAFT POSITION SENSOR *12 PCV VALVE (VENTILATION VALVE SUB-ASSEMBLY) *13 VACUUM PUMP ASSEMBLY *14 GASKET *15 NO...
Categories
Before refueling, close all the doors, windows, and the liftgate/trunk
lid, and switch the ignition OFF.
To open the fuel-filler lid, pull
the remote fuel-filler lid release.

To remove the fuel-filler cap, turn it counterclockwise.
Attach the removed cap to the
inner side of the fuel-filler lid.
read more