Toyota Yaris: Brake System (other) / Vacuum Pump
PrecautionPRECAUTION NOTICE:
This vehicle is equipped with an SRS (Supplemental Restraint System). Failure to carry out service operations in the correct sequence could cause the SRS to unexpectedly deploy during servicing...
COMPONENTS ILLUSTRATION
*1 NO. 1 ENGINE UNDER COVER ASSEMBLY - -
N*m (kgf*cm, ft.*lbf): Specified torque - - ILLUSTRATION
*1 NO...
Other information:
CAUTION / NOTICE / HINT HINT: *: Use the GTS. PROCEDURE 1. VEHICLE BROUGHT TO WORKSHOP
NEXT
2. CUSTOMER PROBLEM ANALYSIS
NEXT
3. PRE-CHECK (a) Measure the auxiliary battery voltage. Standard voltage: 11 to 14 V (ignition switch off) If the voltage is below 11 V, recharge or replace the auxiliary battery before proceeding to the next step...
ON-VEHICLE INSPECTION PROCEDURE 1. INSPECT MASS AIR FLOW METER HINT: Perform "Inspection After Repair" after replacing the mass air flow meter. Click here
(a) Read the value of Data List item "Mass Air Flow Sensor" using the GTS. NOTICE: Perform the inspection of the mass air flow meter while it is installed to the air cleaner cap sub-assembly (installed to the vehicle)...
Categories
No special break-in is necessary, but a few precautions in the first 600
miles (1,000 km) may add to the performance, economy, and life of
the vehicle.
Do not race the engine.
Do not maintain one constant speed, either slow or fast, for a long
period of time.
Do not drive constantly at full-throttle or high engine rpm for
extended periods of time.
Avoid unnecessary hard stops.
Avoid full-throttle starts.
read more