Toyota Yaris: Wiper / Washer / Relay
On-vehicle Inspection
ON-VEHICLE INSPECTION
PROCEDURE
1. INSPECT WINDSHIELD WIPER RELAY
(a) Check the operation of the windshield wiper relay.
| (1) Measure the resistance according to the value(s) in the table below. Standard Resistance: | Tester Connection | Condition | Specified Condition | | 3 - 5 | Auxiliary battery voltage not applied between terminals 1 and 2 | 10 kΩ or higher | | Auxiliary battery voltage applied between terminals 1 and 2 | Below 1 Ω | If the result is not as specified, replace the windshield wiper relay. |
| | *a | Component without harness connected (Windshield Wiper Relay) | | |
INSTALLATION PROCEDURE 1. INSTALL RAIN SENSOR TAPE HINT:
Only perform this procedure when replacing the rain sensor tape.
Replace the rain sensor tape with new one if it is damaged or contaminated...
ComponentsCOMPONENTS ILLUSTRATION
*A w/ Brake Duct Hole - - *1 FRONT FENDER LINER RH - - ILLUSTRATION
*1 WINDSHIELD WASHER MOTOR AND PUMP ASSEMBLY *2 WASHER HOSE RemovalREMOVAL PROCEDURE 1...
Other information:
DISASSEMBLY PROCEDURE 1. REMOVE CENTER STOP LIGHT ASSEMBLY Click here
2. REMOVE NO. 1 REAR SPOILER PROTECTOR (a) Remove the No. 1 rear spoiler protector.
3. REMOVE NO. 2 REAR SPOILER PROTECTOR HINT: Using the same procedure, remove every No...
FAIL-SAFE CHART If any of the following DTCs are stored, the ECM enters fail-safe mode to allow the vehicle to be driven temporarily or stops fuel injection. DTC Code Component Fail-Safe Operation Fail-Safe Deactivation Condition P001100 P001200 VVT system
Intake VVT maximum retarded contact...
Categories
The front seat belt pretensioners are designed to deploy in moderate or
severe frontal, near frontal collisions.
In addition, the pretensioners operate when a side collision or a rollover
accident is detected. The pretensioners operate differently
depending on what types of air bags are equipped. For more details
about the seat belt pretensioner operation, refer to the SRS Air Bag
Deployment Criteria.
read more