Toyota Yaris: Brake System (other) / Brake Pedal

Installation

INSTALLATION PROCEDURE 1. INSTALL BRAKE MASTER CYLINDER O-RING (a) Install a new brake master cylinder O-ring to the brake master cylinder sub-assembly...

Components

COMPONENTS ILLUSTRATION *1 BRAKE PEDAL PAD *2 BRAKE PEDAL RETURN SPRING *3 BRAKE PEDAL SUPPORT ASSEMBLY *4 PUSH ROD PIN *5 STOP LIGHT SWITCH MOUNTING ADJUSTER *6 BRAKE MASTER CYLINDER PUSH ROD CLEVIS *7 CLEVIS LOCK NUT *8 WIRE HARNESS *9 STOP LIGHT SWITCH ASSEMBLY - - Tightening torque for "Major areas involving basic vehicle performance such as moving/turning/stopping" : N*m (kgf*cm, ft...

Other information:

Toyota Yaris XP210 (2020-2026) Reapir and Service Manual: Installation

INSTALLATION CAUTION / NOTICE / HINT HINT: Use the same procedure for the RH side and LH side. The following procedure is for the LH side. PROCEDURE 1. INSTALL ROOF DRIP SIDE FINISH MOULDING CLIP NOTICE: When installing a new roof drip side finish moulding clip, remove any double-sided tape remaining where the roof drip side finish moulding clips will be installed on the vehicle body and clean the vehicle body with a non-residue solvent...

Toyota Yaris XP210 (2020-2026) Reapir and Service Manual: Power Steering Motor "A" Supply Voltage Circuit Voltage Below Threshold (C155A16,C155A17,C155B16,C155B17)

DESCRIPTION If a problem occurs in the system, the power source relay circuit and the motor relay circuit are shut off to stop power assist. The ECU must be replaced when there is a problem with the relays because the relays are built into the ECU. DTC No...