Toyota Yaris: Brake / Parking Brake

Installation

INSTALLATION PROCEDURE 1. INSTALL VACUUM PUMP ASSEMBLY (a) When using new vacuum pump assembly: (1) Apply engine oil to the No. 4 O-ring installed in a new vacuum pump assembly...

Parking Brake Assembly

..

Other information:

Toyota Yaris XP210 (2020-2025) Reapir and Service Manual: Removal

REMOVAL CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during the power window regulator motor removal/installation are shown below...

Toyota Yaris XP210 (2020-2025) Reapir and Service Manual: Brake Actuator Operation Sound is Loud during Initial Check

CAUTION / NOTICE / HINT NOTICE: After replacing the skid control ECU (brake actuator assembly), perform "Calibration". Click here PROCEDURE 1. PERFORM ROAD TEST (a) After turning the ignition switch to ON, compare the operating sound of the brake actuator the first time the vehicle speed reaches approximately 25 km/h (16 mph) with a known good vehicle of the same model...