Toyota Yaris: Brake (rear) / Rear Brake
COMPONENTS ILLUSTRATION
*1 REAR DISC BRAKE PIN HOLD CLIP *2 REAR DISC BRAKE ANTI-RATTLE PIN *3 REAR DISC BRAKE ANTI-RATTLE SPRING *4 REAR DISC BRAKE PAD *5 REAR DISC BRAKE ANTI-SQUEAL SHIM - - ILLUSTRATION
*1 REAR FLEXIBLE HOSE *2 UNION BOLT *3 GASKET *4 REAR DISC BRAKE CYLINDER ASSEMBLY *5 PARKING BRAKE SHOE ADJUSTING HOLE PLUG *6 REAR DISC
Tightening torque for "Major areas involving basic vehicle performance such as moving/turning/stopping": N*m (kgf*cm, ft...
Other information:
REMOVAL CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the front shock absorber assembly removal/installation are shown below...
INSTALLATION PROCEDURE 1. INSTALL AIR CONDITIONER PRESSURE SENSOR (a) Remove the vinyl tape from the No. 2 air conditioner tube and accessory assembly. (b) Sufficiently apply compressor oil to a new air conditioner pressure sensor and the fitting surface of the air conditioner pressure sensor...
Categories
The front and side supplemental restraint systems (SRS) include different
types of air bags. Please verify the different types of air bags
which are equipped on your vehicle by locating the “SRS AIRBAG”
location indicators. These indicators are visible in the area where the
air bags are installed.
The air bags are installed in the following locations:
The steering wheel hub (driver air bag)
The front passenger dashboard (front passenger air bag)
The outboard sides of the front seatbacks (side air bags)
The front and rear window pillars, and the roof edge along both
sides (curtain air bags)
read more