Toyota Yaris: Brake System (other) / Brake Master Cylinder

Brake Line

PrecautionPRECAUTION TROUBLESHOOTING PRECAUTION NOTICE: Since the brake lines are critical safety related parts, be sure to disassemble and inspect the components if a brake fluid leak is found...

Components

COMPONENTS ILLUSTRATION *1 FRONT NO. 1 VENTILATOR SEAL *2 WATER GUARD PLATE RH *3 OUTER COWL TOP PANEL SUB-ASSEMBLY - - N*m (kgf*cm, ft...

Other information:

Toyota Yaris XP210 (2020-2026) Reapir and Service Manual: Power Source Mode does not Change to ON (IG)

DESCRIPTION If the engine switch is pressed with the electrical key transmitter sub-assembly in the cabin, the certification ECU (smart key ECU assembly) receives a signal and changes the power source mode. Related Data List and Active Test Items Problem Symptom Data List and Active Test Power source mode does not change to on (IG) but does change to on (ACC) Power Source Control Power Supply Condition IGP Relay Circuit (Outside) Monitor IGP Relay Circuit (Inside) Monitor IGR Relay Circuit (Outside) Monitor IGR Relay Circuit (Inside) Monitor WIRING DIAGRAM CAUTION / NOTICE / HINT NOTICE: When using the GTS with the ignition switch off, connect the GTS to the DLC3 and turn a courtesy light switch on and off at intervals of 1...

Toyota Yaris XP210 (2020-2026) Reapir and Service Manual: Actuator Supply Voltage "A" Circuit Short to Ground or Open (P065714)

DESCRIPTION The electronic throttle control system has a dedicated power supply circuit. The voltage (+BM, +BM2) is monitored and when it is low (less than 4 V), the ECM determines that there is a malfunction in the electronic throttle control system and cuts off the current to the throttle actuator...