Toyota Yaris: Vehicle Exterior / Lighting (ext)
On-vehicle InspectionON-VEHICLE INSPECTION PROCEDURE 1. INSPECT HORN RELAY ASSEMBLY (a) Check the resistance. (1) Measure the resistance according to the value(s) in the table below...
Other information:
REMOVAL CAUTION / NOTICE / HINT HINT:
Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.
PROCEDURE 1. REMOVE REAR WHEEL Click here
2. REMOVE REAR AXLE SHAFT NUT (a) Using SST and a hammer, release the staked part of the rear axle shaft nut...
ComponentsCOMPONENTS ILLUSTRATION
*1 ROOF TOP MOULDING SUB-ASSEMBLY - - RemovalREMOVAL PROCEDURE 1. REMOVE ROOF HEADLINING Click here
2. REMOVE ROOF TOP MOULDING SUB-ASSEMBLY (a) Remove the nut.
(b) Apply protective tape around the roof top moulding sub-assembly...
Categories
WARNING
When removing the fuel-filler cap, loosen the cap slightly and wait
for
any hissing to stop, then remove it
Fuel spray is dangerous. Fuel can burn skin and eyes and cause illness
if
ingested. Fuel spray is released when there is pressure in the fuel tank and
the fuel-filler cap is removed too quickly.
read more