Toyota Yaris: Lighting (ext) / Automatic Light Control Sensor
INSTALLATION PROCEDURE 1. INSTALL AUTO HIGH BEAM SWITCH (a) Engage the claws to install the auto high beam switch as shown in the illustration.
2...
Other information:
DESCRIPTION If the engine switch is pressed with the electrical key transmitter sub-assembly in the cabin, the certification ECU (smart key ECU assembly) receives a signal and changes the power source mode. Related Data List and Active Test Items Problem Symptom Data List and Active Test Power source mode does not change to on (IG) but does change to on (ACC) Power Source Control
Power Supply Condition
IGP Relay Circuit (Outside) Monitor
IGP Relay Circuit (Inside) Monitor
IGR Relay Circuit (Outside) Monitor
IGR Relay Circuit (Inside) Monitor
WIRING DIAGRAM
CAUTION / NOTICE / HINT NOTICE:
When using the GTS with the ignition switch off, connect the GTS to the DLC3 and turn a courtesy light switch on and off at intervals of 1...
DRIVING ADJUSTMENT CAUTION / NOTICE / HINT NOTICE:
Make sure to read Before Starting Driving Adjustment before proceeding with work.
Click here
Make sure to perform the transition to online axis alignment mode with the vehicle stopped.
Transitioning to online axis alignment mode will erase the learning value, so make sure to complete the adjustment...
Categories

Smart key
Auxiliary key
Key code number plate
To use the auxiliary key, press the knob and pull out the auxiliary key
from the smart key.

read more