Toyota Yaris: Automatic High Beam Main Switch / Installation
INSTALLATION
PROCEDURE
1. INSTALL AUTO HIGH BEAM SWITCH
| (a) Engage the claws to install the auto high beam switch as shown in the illustration. |
|
2. INSTALL LOWER INSTRUMENT PANEL FINISH PANEL ASSEMBLY
Click here
.gif)
3. CONNECT HOOD LOCK CONTROL LEVER SUB-ASSEMBLY
Click here
4. INSTALL NO. 1 INSTRUMENT SIDE PANEL
Click here
5. CONNECT FRONT DOOR OPENING TRIM WEATHERSTRIP LH
Click here
6. CONNECT NO. 1 ROOF HEADLINING MOULDING LH
Click here
7. INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY
Click here
8. INSTALL COWL SIDE TRIM BOARD LH
Click here
9. INSTALL FRONT DOOR SCUFF PLATE LH
Click here
10. INSTALL CONSOLE BOX ASSEMBLY
Click here
11. INSTALL SHIFT LEVER KNOB SUB-ASSEMBLY
Click here
12. INSTALL SWITCH HOLE BASE SUB-ASSEMBLY
Click here
13. INSTALL LOWER INSTRUMENT PANEL FINISH PANEL
Click here
14. INSTALL CENTER LOWER INSTRUMENT COVER
Click here
Inspection
INSPECTION PROCEDURE 1. INSPECT AUTO HIGH BEAM SWITCH (a) Check the resistance. (1) Measure the resistance according to the value(s) in the table below...
Other information:
Toyota Yaris XP210 (2020-2026) Reapir and Service Manual: Removal
REMOVAL CAUTION / NOTICE / HINT HINT: When the cable is disconnected / reconnected to the auxiliary battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used. Learning completes when vehicle is driven Effect/Inoperative Function When Necessary Procedures are not Performed Necessary Procedures Link Lane tracing assist system Drive the vehicle straight ahead at 35 km/h (22 mph) or more for 5 second or more...
Toyota Yaris XP210 (2020-2026) Reapir and Service Manual: Check For Intermittent Problems
CHECK FOR INTERMITTENT PROBLEMS NOTICE: Operation history is stored in the RAM or EEPROM of the certification ECU (smart key ECU assembly). As the cause of a malfunction stored in the RAM will be cleared when the cable is disconnected from the negative (-) battery terminal, do not disconnect the cable from the negative (-) battery terminal before checking and recording are complete...
Categories
- Manuals Home
- Toyota Yaris Owners Manual
- Toyota Yaris Service Manual
- To Set Speed
- Fuse Panel Description
- Auto Lock/Unlock Function
- New on site
- Most important about car
Front Seat Belt Pretensioners
The front seat belt pretensioners are designed to deploy in moderate or severe frontal, near frontal collisions.
In addition, the pretensioners operate when a side collision or a rollover accident is detected. The pretensioners operate differently depending on what types of air bags are equipped. For more details about the seat belt pretensioner operation, refer to the SRS Air Bag Deployment Criteria.
