Toyota Yaris: Lighting (ext) / Headlight Assembly

Hazard Warning Switch

InstallationINSTALLATION PROCEDURE 1. INSTALL HAZARD WARNING SIGNAL SWITCH ASSEMBLY (a) Engage the claws to install the hazard warning signal switch assembly...

Precaution

PRECAUTION NOTICE: When disassembling the headlight assembly, use static electricity countermeasures SST (desktop anti-static mat set) and observe all precautions to prevent damage to the system by electrostatic discharge (ESD)...

Other information:

Toyota Yaris XP210 (2020-2026) Owner's Manual: Key Battery Replacement

If the buttons on the smart key are inoperable and the operation indicator light does not flash, the battery may be dead. Replace with a new battery before the smart key becomes unusable. The following conditions indicate that the battery power is low: The KEY indicator light (green) flashes in the combination meter for about 30 seconds after the engine is switched OFF...

Toyota Yaris XP210 (2020-2026) Reapir and Service Manual: Thermostat

ComponentsCOMPONENTS ILLUSTRATION *1 WATER INLET WITH THERMOSTAT SUB-ASSEMBLY *2 GASKET N*m (kgf*cm, ft.*lbf): Specified torque ● Non-reusable part RemovalREMOVAL CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the water inlet with thermostat sub-assembly removal/installation are shown below...