Toyota Yaris: Headlight Assembly / Precaution

Toyota Yaris XP210 (2020-2024) Reapir and Service Manual / Vehicle Exterior / Lighting (ext) / Headlight Assembly / Precaution

PRECAUTION

NOTICE:

When disassembling the headlight assembly, use static electricity countermeasures SST (desktop anti-static mat set) and observe all precautions to prevent damage to the system by electrostatic discharge (ESD).

STATIC ELECTRICITY COUNTERMEASURES SST

SST: Desktop anti-static mat set (09890-47010)

  • Wristband

    SST:

    09891-04020

  • Wristband connection wire (No. 1 grounding wire)

    SST:

    09891-04030

  • Anti-static mat

    SST:

    09891-04010

  • Ground connection wire (No. 2 grounding wire)

    SST:

    09891-04040

PRECAUTIONS DURING REPLACEMENT

(a) Precautions during procedures:

(1) Before performing any procedures, touch an unpainted metal part or ground bolt of the vehicle to eliminate any static electricity.

(2) To prevent damage to electrical equipment, disconnect the battery power supply before installing and removing electrical equipment.

(3) Never touch the electronic parts of a printed wire board or the pins of an integrated circuit.

(4) When performing procedures, do not allow clothing to come near or contact parts.

(b) Wear SST (wristband) firmly on your wrist.

SST:

09891-04020

(c) Connect SST (No. 2 grounding wire) and SST (anti-static mat) to an appropriate grounding point in the workspace and on the work table.

SST:

09891-04040

09891-04010

HINT:

When working inside the vehicle:

Connect SST (No. 2 grounding wire) to an unpainted metal part or a ground bolt, etc.

(d) Connect SST (No. 1 grounding wire), SST (wristband) and SST (anti-static mat).

SST:

09891-04030

(e) Always place the headlight assembly and its components on SST (anti-static mat).

    Headlight Assembly

    ..

    Components

    COMPONENTS ILLUSTRATION *1 HEADLIGHT ASSEMBLY - - ILLUSTRATION *1 HEADLIGHT LEVELING MOTOR *2 HEADLIGHT LEVELING MOTOR BASE PACKING *3 NO...

    Other information:

    Toyota Yaris XP210 (2020-2024) Reapir and Service Manual: Lost Communication with Cruise Control Front Distance Range Sensor Single Sensor or Center Missing Message (U023587)


    DESCRIPTION The forward recognition camera and millimeter wave radar sensor assembly communicate via CAN communication. If there is an error in the communication with the millimeter wave radar sensor assembly, the forward recognition camera stores DTC U023587...

    Toyota Yaris XP210 (2020-2024) Reapir and Service Manual: Installation


    INSTALLATION PROCEDURE 1. INSTALL STARTER ASSEMBLY (a) Install the wire harness clamp bracket to the starter assembly with the bolt. Torque: 10 N·m {102 kgf·cm, 7 ft·lbf} (b) Install the starter assembly to the cylinder block sub-assembly with the 2 bolts...

    Categories

    Fuel-Filler Lid and Cap

    WARNING

    When removing the fuel-filler cap, loosen the cap slightly and wait for any hissing to stop, then remove it

    Fuel spray is dangerous. Fuel can burn skin and eyes and cause illness if ingested. Fuel spray is released when there is pressure in the fuel tank and the fuel-filler cap is removed too quickly.

    read more

     
    Copyright © 2024 www.toyaris4.com