Toyota Yaris: Lighting (ext) / Fog Light Assembly

Toyota Yaris XP210 (2020-2026) Reapir and Service Manual / Vehicle Exterior / Lighting (ext) / Fog Light Assembly

Back-up Light Assembly

ComponentsCOMPONENTS ILLUSTRATION *1 BACK-UP LIGHT ASSEMBLY *2 BACK-UP LIGHT LED *3 REAR FOG LIGHT LED *4 BACK-UP LIGHT LENS AND BODY RemovalREMOVAL PROCEDURE 1...

Components

C..

Other information:

Toyota Yaris XP210 (2020-2026) Reapir and Service Manual: Removal


REMOVAL CAUTION / NOTICE / HINT HINT: Use the same procedure for the RH side and LH side. The following procedure is for the LH side. PROCEDURE 1. REMOVE FRONT BUMPER ASSEMBLY Click here 2. REMOVE HEADLIGHT ASSEMBLY (a) Apply protective tape around the headlight assembly as shown in the illustration...

Toyota Yaris XP210 (2020-2026) Reapir and Service Manual: Front Passenger Side Electrical Antenna Circuit Open (B27A213)


DESCRIPTION The certification ECU (smart key ECU assembly) generates a request signal and transmits the signal to the front door outside handle assembly RH (electrical key antenna) at intervals of 0.25 seconds. For the front door outside handle assembly RH (electrical key antenna) to detect when the electrical key transmitter sub-assembly is brought close to the vehicle, a signal requesting a response from the electrical key transmitter sub-assembly is transmitted within approximately 1 m (3...

Categories

Break-In Period

No special break-in is necessary, but a few precautions in the first 600 miles (1,000 km) may add to the performance, economy, and life of the vehicle.

Do not race the engine. Do not maintain one constant speed, either slow or fast, for a long period of time. Do not drive constantly at full-throttle or high engine rpm for extended periods of time. Avoid unnecessary hard stops. Avoid full-throttle starts.

read more

 
Copyright © 2026 www.toyaris4.com