Toyota Yaris: Fog Light Assembly / Installation

Toyota Yaris XP210 (2020-2026) Reapir and Service Manual / Vehicle Exterior / Lighting (ext) / Fog Light Assembly / Installation

INSTALLATION

CAUTION / NOTICE / HINT

HINT:

Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.

PROCEDURE

1. INSTALL FOG LIGHT ASSEMBLY

(a) Install the fog light assembly with 3 screws.

2. INSTALL FRONT BUMPER ASSEMBLY

Click here

3. ADJUST FOG LIGHT AIMING

Click here

Adjustment

ADJUSTMENT PROCEDURE 1. PREPARE VEHICLE FOR FOG LIGHT AIM ADJUSTMENT (a) Prepare the vehicle: Ensure that there is no damage or deformation to the vehicle body around the fog lights...

Hazard Warning Switch

InstallationINSTALLATION PROCEDURE 1. INSTALL HAZARD WARNING SIGNAL SWITCH ASSEMBLY (a) Engage the claws to install the hazard warning signal switch assembly...

Other information:

Toyota Yaris XP210 (2020-2026) Reapir and Service Manual: Right Front Wheel Speed Sensor Circuit Short to Ground or Open (C050614)

DESCRIPTION Refer to DTC C05061F. Click here DTC No. Detection Item DTC Detection Condition Trouble Area DTC Output from C050614 Right Front Wheel Speed Sensor Circuit Short to Ground or Open An open in the speed sensor signal circuit continues for 0...

Toyota Yaris XP210 (2020-2026) Reapir and Service Manual: Removal

REMOVAL CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during the transfer assembly removal/installation are shown below...