Toyota Yaris: Vehicle Interior / Theft Deterrent / Keyless Entry

Telltale Light Assembly

ComponentsCOMPONENTS ILLUSTRATION *1 SWITCH HOLE BASE SUB-ASSEMBLY *2 TELLTALE LIGHT ASSEMBLY RemovalREMOVAL PROCEDURE 1. REMOVE SWITCH HOLE BASE SUB-ASSEMBLY Click here 2...

Certification Ecu

ComponentsCOMPONENTS ILLUSTRATION *1 CERTIFICATION ECU (SMART KEY ECU ASSEMBLY) - - RemovalREMOVAL CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the certification ECU (smart key ECU assembly) removal/installation are shown below...

Other information:

Toyota Yaris XP210 (2020-2025) Reapir and Service Manual: Engine/Power Switch Signal Compare Failure (B227862)

DESCRIPTION This DTC is stored when the SSW1 contact signal, SSW2 contact signal and SSW3 contact signal, which are detected when the engine switch is operated, do not match. DTC No. Detection Item DTC Detection Condition Trouble Area Note B227862 Engine/Power Switch Signal Compare Failure When the engine switch is operated, the SSW1 contact signal, SSW2 contact signal and SSW3 contact signal do not match...

Toyota Yaris XP210 (2020-2025) Reapir and Service Manual: Installation

INSTALLATION CAUTION / NOTICE / HINT HINT: Use the same procedure for the RH side and LH side. The following procedure is for the LH side. PROCEDURE 1. INSTALL ROOF DRIP SIDE FINISH MOULDING CLIP NOTICE: When installing a new roof drip side finish moulding clip, remove any double-sided tape remaining where the roof drip side finish moulding clips will be installed on the vehicle body and clean the vehicle body with a non-residue solvent...