Toyota Yaris: Drivetrain / Gf1a (transfer / 4wd / Awd)
INSTALLATION PROCEDURE 1. INSTALL TRANSMISSION CONTROL CABLE ASSEMBLY (a) Pass the transmission control cable assembly through the hole to the outside of the vehicle and install the transmission control cable assembly to the vehicle body with the 2 bolts...
ComponentsCOMPONENTS ILLUSTRATION
*1 DECK TRIM SIDE PANEL ASSEMBLY RH *2 4WD ECU ASSEMBLY
N*m (kgf*cm, ft.*lbf): Specified torque - - RemovalREMOVAL CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during the 4WD ECU removal/installation are shown below...
Other information:
COMPONENTS ILLUSTRATION
*1 REAR AXLE SHAFT NUT *2 REAR SPEED SENSOR *3 REAR FLEXIBLE HOSE *4 CAP *5 REAR STABILIZER LINK ASSEMBLY *6 REAR STABILIZER BAR *7 REAR COIL SPRING *8 REAR LOWER COIL SPRING INSULATOR *9 REAR NO...
If you cannot put all children in the rear seat, at least put the smallest
children in the rear and be sure the largest child up front uses a frontfacing
child-restraint system.
NEVER put a rear-facing child-restraint system on the front passenger
seat whether your vehicle is equipped with a occupant classification
sensor or not...
Categories
The front and side supplemental restraint systems (SRS) include different
types of air bags. Please verify the different types of air bags
which are equipped on your vehicle by locating the “SRS AIRBAG”
location indicators. These indicators are visible in the area where the
air bags are installed.
The air bags are installed in the following locations:
The steering wheel hub (driver air bag)
The front passenger dashboard (front passenger air bag)
The outboard sides of the front seatbacks (side air bags)
The front and rear window pillars, and the roof edge along both
sides (curtain air bags)
read more