Toyota Yaris: Gf1a (transfer / 4wd / Awd) / Transfer Assembly
DESCRIPTION Operate the AWD control switch (No. 2 combination switch assembly) and check that the Data List display and the messages in the multi-information display change according to the switch operation...
COMPONENTS ILLUSTRATION
*1 MANUAL TRANSAXLE ASSEMBLY *2 TRANSFER ASSEMBLY *3 TRANSFER AND TRANSAXLE SETTING STUD BOLT - -
Tightening torque for "Major areas involving basic vehicle performance such as moving/turning/stopping" : N*m (kgf*cm, ft...
Other information:
INSTALLATION CAUTION / NOTICE / HINT HINT:
Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.
PROCEDURE 1. INSTALL REAR AXLE HUB AND BEARING ASSEMBLY (a) Align the matchmarks on the rear drive shaft assembly and rear axle hub and bearing assembly...
TERMINALS OF ECU CHECK POWER DISTRIBUTION BOX ASSEMBLY
(a) Remove the power distribution box assembly. Click here
(b) Reconnect the power distribution box assembly connectors. (c) Measure the voltage and resistance according to the value(s) in the table below...
Categories
Before refueling, close all the doors, windows, and the liftgate/trunk
lid, and switch the ignition OFF.
To open the fuel-filler lid, pull
the remote fuel-filler lid release.

To remove the fuel-filler cap, turn it counterclockwise.
Attach the removed cap to the
inner side of the fuel-filler lid.
read more