Toyota Yaris: Gf1a (transfer / 4wd / Awd) / Transfer Case Front Oil Seal (for Lh Side)
INSTALLATION PROCEDURE 1. INSTALL TRANSFER AND TRANSAXLE SETTING STUD BOLT Click here
2. INSTALL TRANSFER ASSEMBLY (a) Clean the bolt holes. (b) Using SST and union nut wrench, install the transfer assembly to the transaxle with the 6 nuts and 2 bolts...
Other information:
INSPECTION PROCEDURE 1. INSPECT TURBOCHARGER SUB-ASSEMBLY (a) Check if the compressor side impeller and exhaust side turbine are damaged or defective. HINT: Wear on the center of the exhaust side turbine is not a malfunction.
*a Compressor Side Impeller *b Exhaust Side Turbine *c Center of Exhaust Side Turbine (b) Move the rod by hand and check that the waste gate valve is not stuck...
DESCRIPTION Detection Item Symptom Trouble Area Combination Meter ECU Communication Stop Mode Communication stop for "Combination Meter" is indicated on the "Communication Bus Check" screen of the GTS. Click here
Combination meter assembly main line or connector
Power source circuit of combination meter assembly
Combination meter assembly ground circuit
Combination meter assembly
WIRING DIAGRAM
CAUTION / NOTICE / HINT CAUTION: When performing the confirmation driving pattern, obey all speed limits and traffic laws...
Categories
Stop the vehicle completely.
Manual transaxle:
Shift into neutral and set the parking brake.
Automatic transaxle:
Shift the selector lever to the P position and set the parking brake.
Press the push button start to turn off the engine. The ignition position is
off.
read more