Toyota Yaris: Gf1a (transfer / 4wd / Awd) / Transfer System
ComponentsCOMPONENTS ILLUSTRATION
*1 NO. 1 ENGINE UNDER COVER ASSEMBLY *2 TRANSFER FILLER PLUG *3 TRANSFER DRAIN PLUG *4 GASKET
Tightening torque for "Major areas involving basic vehicle performance such as moving/turning/stopping": N*m (kgf*cm, ft...
PRECAUTION PRECAUTION (a) Before disassembling the transfer assembly, thoroughly clean it to remove any foreign matter. This will help prevent contamination inside the transfer during disassembly and reassembly...
Other information:
FAIL-SAFE CHART If any of the following DTCs are stored, the engine stop and start ECU enters fail-safe mode to preserve vehicle operability. DTC Component Fail-safe Operation Fail-safe Deactivation Condition P033562 Open in engine speed signal circuit
Stop and start control is prohibited
Engine is automatically restarted if a DTC is stored while the engine is stopped by stop and start control
All of the following conditions are met for 10 seconds:
Normal communication with ECM
Engine speed 500 rpm or higher
Engine speed (communication signal) 500 rpm or higher
Difference between engine speed from pulse signal and engine speed from communication signal is less than 100 rpm
P055500 P05552A
Vacuum sensor assembly
Brake booster assembly
Vacuum hose (brake booster hose)
Stop and start control is prohibited
Engine is automatically restarted if a DTC is stored while the engine is stopped by stop and start control
One of the following conditions is met:
Vacuum changes while the brake pedal is depressed
Vacuum changes a specified number of times while the vehicle is being driven faster than a certain vehicle speed
P055511 P055515 Vacuum sensor assembly circuit
Stop and start control is prohibited
Engine is automatically restarted if a DTC is stored while the engine is stopped by stop and start control
Sensor output is within standard range P060629 Engine stop and start ECU
Stop and start control is prohibited
Engine is automatically restarted if a DTC is stored while the engine is stopped by stop and start control
Pass condition detected and ignition switch turned to ON P060B1C P060B49 P060B71 Analog to digital converter (Engine stop and start ECU)
Stop and start control is prohibited
Engine is automatically restarted if a DTC is stored while the engine is stopped by stop and start control
Pass condition detected and ignition switch turned to ON P061519 ST NO...
PARTS LOCATION ILLUSTRATION
*1 FRONT DOOR LOCK WITH MOTOR ASSEMBLY RH *2 FRONT DOOR COURTESY LIGHT SWITCH ASSEMBLY RH *3 FRONT DOOR LOCK WITH MOTOR ASSEMBLY LH *4 FRONT DOOR COURTESY LIGHT SWITCH ASSEMBLY LH *5 BACK DOOR OPENER SWITCH ASSEMBLY *6 BACK DOOR LOCK ASSEMBLY WITH COURTESY LIGHT SWITCH ILLUSTRATION
*1 MULTIPLEX NETWORK MASTER SWITCH ASSEMBLY *2 DOOR CONTROL SWITCH *3 MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU) *4 POWER DISTRIBUTION BOX ASSEMBLY - ECU-IGR NO...
Categories
If a key is left in the vehicle, the functions of the key left in the vehicle
are temporarily suspended to prevent theft of the vehicle.
To restore the functions, press the unlock button on the functions-suspended
key in the vehicle.
read more